Efergy Energy metering and monitoring Especificaciones descargar pdf (Pagina 5)

1. Ensure three AA batteries are inserted in the transmitter

and the display unit.

2. Push the Link Button on the reverse of the display unit.

The transmission signal symbol will flash for one minute.

3. While the transmission signal in the display flashes push

the learn button in the transmitter and wait until the

transmission signal symbol becomes solid.

NOTE: The default value for the transmission frequency is

six seconds. This means the transmitter is sending information

every six seconds. You can change the frequency from 6s

(red light flashing) to 12s (orange light) and to 18s (green

light) pushing and holding the transmitter

button.

FIT THE SENSOR

The sensor needs to be fitted to the live feed cable. Sensors are suitable

for cables up to 12mm in diameter. You should not force the cable to fit.

1. Push the release cap

to open the sensor.

3. Close the sensor.

The sensor is secure

when a “click” is heard.

2. Select the correct

feed cable, then place

the feed cable into the

top of the sensor.

LINKING THE TRANSMITTER AND THE DISPLAY

INSTALLATION

If the LINK is NOT

COMPLETED you will see

dashes on the display.

QUICK HINT:

If the LINK is COMPLETED

you will see the transmission

signal symbol

PLUG THE SENSOR CABLE INTO THE TRANSMITTER

Insert the jack on the end of the white wire into any of the three input sockets on the

transmitter. The clip-on sensor acts as a current sensor and relays the current being drawn

link

learn

Feed Wire

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Efergy Energy metering and monitoring Especificaciones Pagina 5