Efergy Energy metering and monitoring Especificaciones descargar pdf (Pagina 3)

Your Efergy Pack includes:

1x Sensor

1x Transmitter

1x Display Unit

Display Unit

Sensor

IN THE BOX

You will need to fit the sensor to the live feed cable

which connects the meter to the fuse box (consumer

unit). Any power you use in your home will pass

through this cable.

The clip-on sensor acts as a current sensor, and

relays the amount of current being drawn in the

home to the transmitter. From there it is sent wirelessly

to the monitor display unit, which shows

how much power is being consumed.

Transmitter

IT IS IMPORTANT THAT YOU OBSERVE SOME SIMPLE PRECAUTIONS BEFORE USING

THIS PRODUCT.

When installing the Efergy monitor you should find that everything is relatively straight-

forward. However, there are number of important health and safety issues which you need

to be aware of.

It is recommended that you contact a qualified electrician to carry out the installation. The

sensor clip fits onto the internal live feed cable inside the electricity meter or fuse box,

which delivers the live supply to your home. In some countries (i.e. Australia) the live cable

can only be accesed by a qualified electrician. Contact Efergy to find out if it’s mandatory

for you to use a qualified electrician in your country.

Please read and act upon the important information on the following pages. Remember

the device is not intrusive and does not require any rewiring.

If you notice anything unusual about the electricity supply or the fuse box, such as loose

wires, exposed cabling, burn marks, holes in the insulating materials or damage to the

meter, then stop immediately and report the findings to your supply company.

Do not force or bend the cables at any point during the installation.

If you are worried or have any concerns about the installation, please contact a qualified

electrician immediately.

The user does not need to remove the sensor through the working life of the unit. Battery

changes are performed on the transmitter and on the display. There are no batteries to

change in the sensor.

SAFETY

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Efergy Energy metering and monitoring Especificaciones Pagina 3