Efergy Energy metering and monitoring Especificaciones descargar pdf (Pagina 14)

9. Single tariff setup

The electricity monitor must be programmed with the correct unit cost per kWh if it is to provide

you with accurate cost readings. Set the tariff as follows (valid only if you DO NOT have a dual

tariff meter):

First enter the settings mode: Press and hold in [unit/set] for two seconds.

N.B. If no button is pushed for 20 seconds the display will go back to normal display mode

without saving any changes.

Step 1. Voltage

Press and hold in [unit/set] for two seconds. 230* ﬂashes

(230 V is the default setting). Change the voltage using

the [◄] and [►] buttons if you have a different mains

voltage. Press [unit/set] to conﬁrm and to advance to the

currency setting.

* Even if you have a 400 V supply, the voltage per phase

is 230 V.

Step 2. Currency

Set the correct currency (kr, €, $ or ₤) using the using the

[◄] and [►] buttons. Press [unit/set] to conﬁrm and to

advance to the tariff setting.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Sin comentarios

Efergy Energy metering and monitoring Especificaciones Pagina 14