Efergy Energy metering and monitoring Manual de instrucciones descargar pdf (Pagina 6)

SET-UP INSTRUCTIONS

SETTING THE TIME & DATE

The efergy monitor needs to know the time and date in order to provide you with the correct

information. Set the time and date as follows:

2 seconds

Step 1

On the reverse of the display you will find the TIME button.

Press and hold for two seconds. Date set up will flash in

the display.

Step 2

Set the date by using the BWD and FWD Buttons. Press

Mode Button to confirm and move to month set up.

Repeat the process to set the year. Press Mode Button

once to save and move onto time set up.

Step 3

Set the hour to the correct time by using BWD and FWD

Buttons. Press Mode button once to save the hours.

Repeat for minutes, using the Mode button to confirm.

Once the correct time and date have been set, push

History button to save and exit.

BWD FWD ModeHistory

The efergy monitor needs to know unit cost per kWh charged by your electricity supplier,

along with voltage and alarm settings.The following four steps will move through each of

these settings. If you have dual tariff or a rate meter, please see overleaf.

Press and hold down Mode Button for two

seconds, this will enable you to enter the setting

mode.

Step 1. Voltage

Press and hold Mode button for two seconds.

Default voltage is set at 240V. Use BWD and FWD

Buttons to change the voltage. Press Mode button

to save your setting and move into currency

selection setting.

Step 2. Currency Selection

Select the currency using BWD and FWD Buttons.

Default currency will be “£”. Push Mode button to

confirm and to move onto tariff selection set up.

Note: 20 seconds of inactivity in setting mode will

return the unit to normal display mode without

saving changes.

2 seconds

BWD FWD ModeHistory

BWD FWDHistory

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Efergy Energy metering and monitoring Manual de instrucciones Pagina 6